Custom stainless steel braided power steering hose kit for Ford rack and pinion to GM or Ford steering pumps.
Fits one-piece cast aluminum rack housings, including TRW built Mustang II, Thunderbird and late model Mustang.
Installation consists of routing, measuring, cutting, and assembling one end of each hose.
Includes:
Rack Housing Compatibility:
There are 2 different sizes of hose that come in our base power steering hoses kits. There is a 3/8 I.D. hose for the return and a 5/16 I.D. hose for the pressure side. All base hose kit come with 22” of hose. They are a cut to fit application at pump end. The hose kits listed below are for pumps with reservoir attached. If you are running a pump where the reservoir is mounted separately then you need to order the third line kit.
These fittings seal at the face of the rack with the white Teflon seals and with a hidden O-ring built into the middle of the nut on the fitting. You do not want to over tighten these fittings or you will damage the white seals. Tighten rack side fittings to about 12-14 ft/lbs. Both fittings will swivel once they have been installed and tightened.