A/C and Heater
Gotta Show A/C hose kits are made using 100% stainless steel construction (not plated) and come ready to polish. All fittings are female 'o-ring' formed, making them compatible with any aftermarket Air Conditioning system.
Any company with a T-400 Weatherhead machine and 46C dies can crimp the fittings after the purchaser has marked them to their particular specifications. Or, the fitting can be sent back to Gotta Show for crimping (nominal fee applies).
Hoses are made from aircraft quality TEFLON®* lined stainless steel and have been tested in Arizona using 134-A refrigerant on real vehicles. This real-world testing has provided leak-free service for over 5 years. Additionally, the fittings and hoses have over 2000 continuous hours of testing on a modified whip running at 170 rpm with a 4" oscillation.
All A/C hose kits come with your choice of bend angle (135°, 90°, 45°, or straight off the compressor), and with or without service ports. Each basic kit comes with 2 sizes of hose equaling 15 ft, (2) #6 90-degree drier fittings, (1) #6 45-degree and (1) # 8 45-degree condenser fittings, (1) #6 90-degree and (1) # 10 90-degree bulkhead or evaporator fittings. Custom kits are available as special order. All A/C kits are cut to fit. The instructions in the kit explain what specific crimp style is needed to crimp the lines.
Heater Hose Kits
Heater hose kits come with 10 ft of braided stainless TEFLON® inner lined hose with a #8 AN fitting swedged on both ends of the hose, Two (2) #10 long drop fittings for bulkhead which allow adequate clearance for the A/C fittings attached to the bulkhead. This creates a clean look and allows routing of the A/C and heater lines together for a show quality look. Adapters for intake manifold and water pump are included, based on your setup.